Power House Tool's Bridge
    Micrometer and all tools
        make maintenance a snap!

Click on any photo to enlarge

jack bolt

Please specify the length, diameter and thread required and we will quote to those specifications.


stud protractor

This tool makes tightening a bolt to the exact degree easy. Just open up the protractor to the desired degree and using the measuring arm, mark the casing. Use the other measuring arm to mark the nut. Tighten the nut until casing and nut marks are aligned. Power House Tool, Inc. supplies an extra nipple for larger diameter holes.
Model Number: CG18


packing tooth scraper

Extra tool bits are available.
SE2

Running the PTS01 over the damaged teeth on the steam packing will re-establish the tapered edges. The adjustable tool bits conform with the original packing. The handle has a knurled black oxide finish for a longer life.
Model Number: PTS01

bridge micrometer

Model
Number
Body Length
(inches)
Bridge Length
(inches)

BM06-K
4-1/2
1-3/4
BM08-K
5-1/2
2-1/2
BM12-K
8
4

This bridge micrometer will read elevation differences between two joints, heights of welds, crush pins, diaphragm keys and diaphragm springs. Tool comes with 2 inch Starrett micrometer head.


chain indicator holder

Starting at 1/2 inch diameter shafts, this chain indicator can check alignment on just about any size diameter shaft by just adding chain. Unit comes with a 24 inch chain.
Model Number: CIH


brass wedges

Model
Number
Width
(inches)
Length
(inches)
Height
(inches)

BWA
1/2
3
1/4
BWB
3/4
3 1/2
1/2
BWC
1
5 3/4
1/2

Brass wedges for wedging diaphragm & packing against seal face to take clearance readings.

 







Power House Tool, Inc.
167 Oswalt Ave.
Batavia, IL 60510
Phone: (815) 727-6301


Copyright © 2011 Power House Tool, Inc.
All Rights Reserved.